Visionworks Photography

 

Weddings Newsletter

 

Loading...

 

 

The Windsor Knot is a thick, wide and triangular tie knot. It is best suited for spread collar shirts. While just about everyone can use this tie knot to tie his tie, it tends to look better on men with longer necks as its wide form shortens the perceived height of the neck a little bit. Simply follow the steps below to tie your Windsor Knot:

   
1) The wide end "A" should extend about 30cm below narrow end "B". Cross wide end "A" over narrow end "B".
2) Bring wide end "A" up through loop between collar and tie; then back down.
3) Pull wide end "A" underneath narrow end "B" and to the left, back through the loop and to the left again so that the wide end "A" is inside out.
4) Bring wide end "A" across the front from left to right.
5) Pull wide end "A" up through the loop again.
6) Bring wide end "A" down through the knot in front.
7) Using both hands, tighten the knot carefully and draw up to collar .